Lotus Drivers Club Online
The Lotus Drivers Club, The Friendly Lotus Club


Welcome to the Lotus Drivers Club Online Community. Please register yourself below with a username and password to allow you to add topics, post information and more. If you are already registered log in below.


Visit our new website at www.LotusDriversClub.org.uk and check out our events calendar for 2009 along with all the latest news, photos and information about the Club.


If you have any queries or questions please email them to lotusdriversclub-cj@yahoo.co.uk

Join the forum, it's quick and easy

Lotus Drivers Club Online
The Lotus Drivers Club, The Friendly Lotus Club


Welcome to the Lotus Drivers Club Online Community. Please register yourself below with a username and password to allow you to add topics, post information and more. If you are already registered log in below.


Visit our new website at www.LotusDriversClub.org.uk and check out our events calendar for 2009 along with all the latest news, photos and information about the Club.


If you have any queries or questions please email them to lotusdriversclub-cj@yahoo.co.uk
Lotus Drivers Club Online
Would you like to react to this message? Create an account in a few clicks or log in to continue.

S1 111S MIL light

2 posters

Go down

S1 111S MIL light Empty S1 111S MIL light

Post  softlips Fri Mar 20, 2009 9:22 pm

The MIl light is coming on on my S1 111S on the overun. It is off the rest of the time, OK through all the revs. But if I lift off at speed, or gear down for a corner the MIL light flashes or even stays on.

It's also ticking over a little rough and lumpy - seems to be hunting around the revs a bit. Cleaned the ICAV and reset the throttle sensor but no help.

Any ideas?

softlips
Lotus Drivers Club Member
Lotus Drivers Club Member

Number of posts : 5
Location : Rotherham
Registration date : 2009-03-07

Back to top Go down

S1 111S MIL light Empty Re: S1 111S MIL light

Post  A7ESK Fri Mar 20, 2009 9:54 pm

This should help.

My S2 does a similar thing - I'm convinced that it's a common problem. The fault code clears itself after a few warm-ups but then the MIL comes on again. Usually happens after a long run, when coming off the M-way and changing to stop/start driving. I bought (www.obd-2.com - much cheaper than main dealer diagnostics or a Lotus ScanTool!) to read what the code is and reset the MIL. I always seem to get P0137 (post cat O2 sensor low voltage) - it would be interesting to see what code everone else is getting.

Eddie King. bounce
A7ESK
A7ESK
Midlands Area Meet Coordinator
Midlands Area Meet Coordinator

Number of posts : 581
Location : Kenilworth
Registration date : 2008-07-18

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum